液压摆式数控剪板机QC12K-4*2500Estun

    2018-10-18 09:37
液压摆式数控剪板机QC12K-4*2500Estun

 

性能特点:

本机器采用钢板焊接结构,机身采用有限元分析设计、振动时效消除内应力,使机身稳定、可靠。

◎采用三点支撑滚动导轮,消除支撑间隙,提高剪切精度。

◎刀架剪切角能在一定的范围内调整,可使剪切材料变形量减小到理想状态,又可剪切超厚板料。

◎剪切行程任意调整,提高了工作效率,又可实现分段剪切功能。

◎后挡料设计了手动抬升功能,便于超长板料剪切。

◎墙板内侧设有手动,操作方便,保证关键部位的润滑。

◎插装式液压系统,减缓油温提升,增强机床运行的可靠性和安全性。

◎标配采用Delem专用系统,剪切计数、后挡料、剪切角及刀口间隙的调节直观、简单、方便。

◎可选用DAC310、DAC360数控系统以满足更高精度要求的剪切和控制。

 

Performance features:

This machine adopts the welded structure of the steel plate, and the fuselage is designed and vibration aging is eliminated and the

internal stress is eliminated, so the fuselage is stable and reliable..
Using the three point support rolling guide, eliminate the support gap, improve the cutting precision.
a shearing angle can be adjusted in a certain range, can reduce the shearing deformation, and shear super thick material.
The shearing stroke adjust, improve work efficiency, and can realize sectional shear function.
The rear stopper is designed for manual lifting function, long sheet metal shear.
The inner side of the wall with manual pumps, convenient operation, ensure the lubrication of the key parts.
The plug-in type hydraulic system, slow temperature increase, enhance the reliability and safety operation of machine.
a standard uses a special system of delem, counting shearing, the block material, shear angle and cutting edge gap

visual adjustment, simple and convenient.
You can choose DAC310, DAC360 CNC system to meet the control requirements of shear and high accuracy.

 

摆式剪板机维护保养的方法

1、严格按照操作规程进行操作。

2、每次开机前按润滑图表要求定时、定点、定量加润滑油,油应清洁无沉淀。

3、机床必须经常保持清洁,未油漆的部分应涂抹防锈油脂。

4、电动机轴承内的润滑漾油要定期更换加注,并经常检查电器部分工作是否正常安全可靠。

5、定期检查链条、手柄、旋钮、按键是否损坏,磨损严重的应及时更换,并报备件补充。

6、定期检查修理开关、保险、手柄、保证其工作可靠。

7、每天下班前10分钟,对机床加油润滑及擦洗清洁机床。

8、严禁非指定人员操作该设备,平常必须做到人离机停